DeWalt DCMWSP650Y2 Lawn Mower Manual

The DeWalt DCMWSP650Y2 is a 65V MAX* 21-inch Self-Propelled Cordless Electric Lawn Mower, part of the FLEXVOLT ADVANTAGE system. It features a brushless motor, 7.5Ah battery, variable speed self-propel drive, 6-position single-lever height adjustment, mulching/bagging/side discharge capabilities, LED headlights, and weather-resistant construction. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 21-inch steel deck, FLEXVOLT ADVANTAGE 65V MAX* battery system, Brushless motor, Variable speed self-propel drive, 6-position height adjustment lever, Mulching plug, Grass bag, LED headlights, Weather-resistant construction.

Assembly & Setup

Unpack and inspect all parts. Assembly requires basic tools (included).

1. Attach the Lower Handle: Secure to deck using provided bolts and wrench.
2. Attach the Upper Handle: Connect to lower handle, secure knobs.
3. Install the Grass Bag: Attach bag support frame to rear deck, hook bag onto frame.
4. Install the Mulching Plug (if mulching): Insert into rear discharge chute.
5. Install Battery: Insert fully charged 65V MAX* battery into battery compartment.
6. Adjust Cutting Height: Set lever to desired position (test on a small area first).

WARNING! Ensure mower is powered OFF and battery is removed during assembly. Tighten all fasteners securely.

First-Time Operation

Before first mow, read all safety instructions. Ensure area is clear of debris.

1. Insert Safety Key: Push fully into slot near handle.
2. Insert Battery: Slide charged battery into compartment until it clicks.
3. Adjust Height: Set cutting height appropriate for your grass type.
4. Start Mower: Hold safety bail handle against upper handle, then press and hold start button.
5. Engage Self-Propel: Squeeze drive control lever to desired speed.
6. Mow: Overlap passes slightly for even cut. Avoid mowing when grass is wet.
7. Shut Down: Release drive lever, release bail handle, remove safety key.

CAUTION! Always wear appropriate safety gear (eye protection, sturdy footwear). Keep bystanders clear.

Specifications

• Model: DCMWSP650Y2
• Power System: 65V MAX* FLEXVOLT ADVANTAGE
• Battery Included: DCB615 65V MAX* / 20V MAX* 7.5Ah
• Cutting Width: 21 inches
• Cutting Height Range: 1.5 - 4 inches (6 positions)
• Drive: Variable Speed Self-Propelled (Forward)
• Deck Material: Steel
• Wheels: 8" rear, 7" front
• Weight (without battery): Approx. 65 lbs
• Charge Time (approx.): 60 minutes with DCB115 charger
• Run Time (approx.): Up to 60 minutes on a single charge (varies with conditions)

Controls and Settings

Primary controls located on the upper handle for easy operation.

Handle Controls: Safety Bail Handle (must be held to run), Start Button, Drive Control Lever (variable speed), Height Adjustment Lever.

Deck Features: Discharge Chute (for side discharge), Mulching Plug, Bag Attachment Point.

Battery Compartment: Located at rear of mower. Battery Fuel Gauge shows charge level.

Settings: Cutting Height (Lever positions 1-6, 1=lowest, 6=highest). Drive Speed (controlled by pressure on lever).

Cutting & Drive Modes

Three cutting modes: Mulching, Bagging, Side Discharge.

1. Mulching: Install mulching plug. Cuts clippings finely and returns them to lawn as fertilizer.
2. Bagging: Attach grass bag. Collects clippings for disposal.
3. Side Discharge: Remove both plug and bag. Discharges clippings to the side (use with catcher if needed).
4. Self-Propel Drive: Squeeze lever to engage. Speed varies with pressure. Release to stop drive (blade continues).

Tip: For best mulching, mow frequently and avoid cutting more than 1/3 of grass height at once.

Battery & Charging

Uses DeWalt 65V MAX* / 20V MAX* FLEXVOLT ADVANTAGE batteries.

1. Charging: Use DeWalt DCB115 charger (or compatible). Plug charger into outlet, insert battery. LED indicates status (red=charging, green=fully charged).
2. Battery Care: Store in cool, dry place. Do not expose to extreme heat or cold. Charge battery before storage if not used for 30+ days.
3. Fuel Gauge: Press button on battery to display remaining charge (LEDs: 4=full, 1=low).
4. Run Time: Varies with grass height, density, and drive speed. For maximum run time, use lower drive speed and appropriate cutting height.

WARNING! Use only DeWalt chargers and batteries. Do not charge damaged batteries.

Maintenance & Storage

Regular maintenance ensures optimal performance and longevity.

1. After Each Use: Clean underside of deck (remove grass clippings). Check blade for damage.
2. Blade Sharpening/Replacement: Disconnect battery. Tip mower on its side (air filter side up). Use wrench to remove blade bolt. Sharpen or replace as needed. Ensure blade is balanced.
3. Wheel & Drive Inspection: Check wheels for free movement. Lubricate wheel axles if necessary.
4. End-of-Season Storage: Fully charge battery. Clean mower thoroughly. Store in a dry, protected area. Consider removing battery for separate storage.

CAUTION! Always remove battery before performing any maintenance. Ensure mower is completely powered off.

Safety Information

Read and understand all instructions before use. Failure to follow warnings can result in serious injury.

• Always wear eye protection and substantial footwear.
• Keep hands and feet away from rotating blade and discharge area.
• Do not mow on steep slopes. Mow across slopes, not up and down.
• Clear mowing area of stones, sticks, wire, and other objects.
• Never allow children or untrained persons to operate mower.
• Do not operate mower in rain or wet conditions.
• Use the safety key. Remove it when mower is not in use.
• Be aware of the mower discharge direction. Do not point at people, animals, or windows.

Warranty & Support

DeWalt DCMWSP650Y2 is backed by a 3-year limited warranty (battery: 3-year, tool: 3-year). Proof of purchase required. This product is designed for residential use.

Macrovision / Copyright: DeWalt and the yellow/black color scheme are trademarks of DeWalt, a Stanley Black & Decker company.

For technical support, replacement parts, or warranty service:

• Visit: www.dewalt.com
• Call: 1-800-4-DEWALT (1-800-433-9258)

Troubleshooting

Reset: If electronic controls behave unexpectedly, remove battery and safety key for 60 seconds, then reinsert.

Service: For repairs not covered in this manual, contact DeWalt authorized service centers.